 V8 disassimbly - help, front pulley and dampner |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DougC |
 Aug 27 2004, 08:53 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 949 Joined: 6-July 04 From: Dallas, TX Member No.: 2,307  |
Anyone here know how to remove the pulley and dampner assembly on the front crank? This one does not have a visible bolt (inside the assembly). It's a SBC 283 that was original to 1960. Also has rivets (kind of) that attach the pulley to the dampner so I assume they come off together with a big puller maybe? An engine building book I have says that some motors came this way but doesn't give procedures for removal in this case..all help would be greatly appreciated!
Doug C |
   |
 
|
  |
Replies
| Verruckt |
Aug 28 2004, 12:13 AM
Post
#2
|
|
Senior Member Group: Members Posts: 716 Joined: 14-July 04 From: Midwest Member No.: 2,348 |
Pully should be bolted to the damper. The damper should have one large bolt on the crank. If you plan on reusing the damper, you will need to be VERY careful pulling it off. Otherwise you will just pull off the outer ring, and you would be screwed at that point. Maybe there is 40 years of crud hiding the flats on the boltheads?
|
|
|
|
Posts in this topic
DougC V8 disassimbly - help Aug 27 2004, 08:53 AM
neo914-6 I have not seen a pulley type that was not bolted.... Aug 27 2004, 09:53 PM
cametal You will need to remove the pulley then use a harm... Aug 28 2004, 12:17 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:00 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.