 How to remove ignition switch, On a '75 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| brooks944 |
 Jan 3 2015, 09:51 AM
Post
#1
|
|
Member  Group: Members Posts: 249 Joined: 5-September 10 From: Kingston, TN Member No.: 12,139 Region Association: South East States  |
I'm trying to replace my ignition switch on my 75, 1.8L. I've been following the Pelican write up but my car doesn't have the two screws to pull the switch as shown in Pelican figure 10. How do you get this thing out on a '75? Photo of my car attached.
Thanks, Rick  |
   |
 
|
  |
Replies
| PBC914 |
Jan 3 2015, 06:58 PM
Post
#2
|
|
Member Group: Members Posts: 192 Joined: 30-December 10 From: Minneapolis Member No.: 12,545 Region Association: Upper MidWest |
You don't need a drift for this job. It's easy remove the c clip from around the steering shaft and the entire piece slides off.
|
|
|
|
Posts in this topic
brooks944 How to remove ignition switch Jan 3 2015, 09:51 AM
brooks944 I got the tumbler out. Do you have to pull the wh... Jan 3 2015, 11:22 AM Jeff Bowlsby What are you trying to do? Did you unplug the har... Jan 3 2015, 11:26 AM brooks944 Thanks Jeff. Yes all harnesses are disconnected. ... Jan 3 2015, 11:29 AM Jeff Bowlsby Don't think so its tiny, and I am pretty sure ... Jan 3 2015, 12:08 PM StratPlayer http://www.pelicanparts.com/techarticles/9...tion_... Jan 3 2015, 12:10 PM SLITS The '75-'76 comes apart differently than t... Jan 3 2015, 12:36 PM brooks944 Thanks, these are very helpful. It looks like it... Jan 3 2015, 01:32 PM brooks944 Thanks Ron with you photos I got it out and replac... Jan 3 2015, 03:02 PM SLITS If you are talking about the crush ring that goes ... Jan 3 2015, 03:53 PM brooks944 Yes, that's exactly what it is. It is making ... Jan 3 2015, 04:04 PM SLITS If you have the assembly in position on the steeri... Jan 3 2015, 05:22 PM brooks944 I'm sure I can get in in and secured, but what... Jan 3 2015, 05:28 PM
SLITS
I'm sure I can get in in and secured, but wha... Jan 3 2015, 06:55 PM PBC914 You're close! Remove the c-clip from arou... Jan 3 2015, 06:48 PM brooks944 Thanks guys, got it done. What a Pain. About 4 h... Jan 4 2015, 10:53 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 02:30 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.