Liquid welds on the tranny case, JB Weld, Permatex Gear Oil RTV Gasket Maker, ?? Options

[Hank914]

I have a tranny case leak that needs a repair. Here is a pic of the leak, which when warmed up is about one large drop a second.




I figure that I should do a real weld for the permanent fix, but would like to do a temp fix so I can drive over to my welder brother-in law about a 100 miles away.

So, what is the best liquid weld goop for this type of a hole (about 1-2 mm in diameter)?

[johnhora]

I've used JB Weld on 911 mag intake manifolds before and it held up just fine.
This was to repair a crack in one of the mounting holes on the end. It's a spot that gets tightened down too hard and can crack. The JB Weld held and still is....think I may still have it and will take a picture.
The only thing is it was off the car and cleaned up and prepped before using.
Might be harder with the leak for it to dry properly....