 What is the best way to reseal the bottom of a relay board? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Geezer914 |
 Feb 18 2015, 07:53 AM
Post
#1
|
|
Geezer914  Group: Members Posts: 1,433 Joined: 18-March 09 From: Salem, NJ Member No.: 10,179 Region Association: North East States 
 |
I removed the old cracked tar form the relay board. What is the best stuff to use on the bottom of a relay board to seal the copper strips?
|
   |
 
|
  |
Replies
| barefoot |
Feb 18 2015, 08:35 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,279 Joined: 19-March 13 From: Charleston SC Member No.: 15,673 Region Association: South East States
|
QUOTE(Geezer914 @ Feb 18 2015, 08:53 AM)  I removed the old cracked tar form the relay board. What is the best stuff to use on the bottom of a relay board to seal the copper strips? Epoxy would be good as it's non-conductive. I use the WEST system stuff sold at most marine stores cause I do some marine fabrications Probably the stuff you can clear coat table tops with would work as well Acrylic I think |
|
|
|
Posts in this topic
Geezer914 What is the best way to reseal the bottom of a relay board? Feb 18 2015, 07:53 AM
bulitt There was a thread on using Plasti-dip. Feb 18 2015, 08:13 AM Bartlett 914 I used a product from Smooth-on
Casting rubber
I... Feb 18 2015, 08:50 AM BeatNavy I used Liquid Tape from Home Depot. I think I... Feb 18 2015, 09:00 AM StratPlayer Liquid tape Feb 18 2015, 10:12 AM timothy_nd28 For circuit boards, I use humiseal Feb 18 2015, 10:13 AM Markl I used spray-on Plasti-Dip several years ago - sti... Feb 18 2015, 10:28 AM Geezer914 Thanks for all the info. I just ordered a tube of... Feb 18 2015, 10:29 AM
Dave_Darling Trot over to Radio Shack (or your local electronic... Feb 18 2015, 11:42 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 02:35 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.