 Ignition wiring, beat to death, I know |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Cfletch |
 Jun 8 2015, 10:37 PM
Post
#1
|
|
Member  Group: Members Posts: 211 Joined: 30-January 14 From: Santa Barbara Member No.: 16,941 Region Association: Southern California  |
Looking for a Ignition CM for my 1974 2.7l engine. I see the MSD 6201 Digital 6A on pelican and I am wondering if i'll run into any issues with that, and also what else would I need?
|
   |
 
|
  |
Replies
| Cfletch |
Jun 9 2015, 08:36 AM
Post
#2
|
|
Member Group: Members Posts: 211 Joined: 30-January 14 From: Santa Barbara Member No.: 16,941 Region Association: Southern California |
I think I'll go with that unit I mentioned. Do you have the coil part number? And with the cd and the new coil I should be ok as far as ignition correct?
|
|
|
|
Posts in this topic
Cfletch Ignition wiring Jun 8 2015, 10:37 PM
matthepcat You can run an old Bosh CDI with a basic coil. Run... Jun 9 2015, 12:03 AM Mark Henry MSD 6AL now has a rev limiter built in, no more pi... Jun 9 2015, 06:06 AM MJHanna Also look at the MSD streetfire.
http://www.msdp... Jun 9 2015, 06:34 AM MJHanna
I think I'll go with that unit I mentioned. D... Jun 9 2015, 09:37 AM
Cfletch
I think I'll go with that unit I mentioned. ... Jun 9 2015, 10:06 AM Mark Henry
Because according to Mark the model mentioned ha... Jun 9 2015, 11:17 AM Cfletch
Because according to Mark the model mentioned h... Jun 9 2015, 01:36 PM sixnotfour MSD Digital 6A and 6AL Ignition Control
6A - PN 62... Jun 9 2015, 11:34 AM MJHanna
Because according to Mark the model mentioned h... Jun 9 2015, 12:41 PM screenguy914 I think it's as important to ditch the factory... Jun 9 2015, 07:15 PM Cfletch
I think it's as important to ditch the factor... Jun 9 2015, 08:37 PM Cfletch So I got my parts today, Im running the MSD 6AL wi... Jun 11 2015, 09:04 PM Mark Henry The diagram is correct, the pertronix coil wires n... Jun 12 2015, 09:04 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st December 2025 - 12:53 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.