 Installed, floor pan deflectors |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| cpavlenko |
 Jun 23 2015, 12:31 PM
Post
#1
|
|
Member  Group: Members Posts: 489 Joined: 19-April 12 From: North Arizona Member No.: 14,400 Region Association: Southwest Region  |
Wasn't to bad, would've been much easier with a 4 post lift. I only had drive up ramps and jack stands. All went well.
  |
   |
 
|
  |
Replies
| cpavlenko |
Jun 23 2015, 02:56 PM
Post
#2
|
|
Member Group: Members Posts: 489 Joined: 19-April 12 From: North Arizona Member No.: 14,400 Region Association: Southwest Region |
well, it's 105 degrees out side, and I took the teener out for a 40 mile cruise. when I got back home and checked my oil temp dip stick, it was at 250 degrees. this is to hot, seemed to run cooler without the flaps? so what I'm going to do is remove them and take the same cruise tomorrow and see if there's a difference. also I'm going to put the right clamps on. I have some extras. Air cooled only did that, and I'm going to call bout that. the temp is going to be the same here tomorrow.
|
|
|
|
Posts in this topic
cpavlenko Installed Jun 23 2015, 12:31 PM
JStroud Looks good, next upgrade I would do is replace the... Jun 23 2015, 12:43 PM cpavlenko Rubber fuel line hose through the whole car was co... Jun 23 2015, 01:02 PM Cevan I'd suggest using FI clamps instead of the one... Jun 23 2015, 01:56 PM
Chris914n6
I'd suggest using FI clamps instead of the on... Jun 23 2015, 03:12 PM 914Mels Stupid question, but what purpose do the deflector... Jun 23 2015, 02:05 PM cpavlenko
Stupid question, but what purpose do the deflecto... Jun 23 2015, 09:27 PM screenguy914
well, it's 105 degrees out side, and I took t... Jun 23 2015, 04:28 PM cpavlenko
well, it's 105 degrees out side, and I took ... Jun 23 2015, 08:57 PM cpavlenko stock 1971 1.7. no frills. Jun 23 2015, 04:42 PM budk The plastic flaps or deflectors are to create a lo... Jun 23 2015, 06:50 PM cpavlenko
The plastic flaps or deflectors are to create a l... Jun 23 2015, 08:45 PM Garold Shaffer
The plastic flaps or deflectors are to create a ... Jun 23 2015, 08:49 PM cpavlenko
[quote name='cpavlenko' post='2201833' date='Jun ... Jun 24 2015, 01:59 PM rudedude Where did you find a set of new looking deflectors... Jun 23 2015, 07:28 PM cpavlenko
Where did you find a set of new looking deflector... Jun 23 2015, 08:51 PM Eric_Shea Don't bother taking them off. That's not y... Jun 24 2015, 08:09 AM cpavlenko
Don't bother taking them off. That's not ... Jun 24 2015, 08:58 AM rhodyguy Just release the bellows control wire at the rod a... Jun 24 2015, 08:21 AM SLITS Did you clean your on engine oil cooler?
While yo... Jun 24 2015, 08:49 AM cpavlenko
Did you clean your on engine oil cooler?
While y... Jun 24 2015, 09:00 AM rhodyguy Try ron's idea first. Jun 24 2015, 08:57 AM rhodyguy Put a catch basin on the floor under the cooler. I... Jun 24 2015, 09:08 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th March 2026 - 05:00 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.