![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
Brett W |
![]()
Post
#1
|
Advanced Member ![]() ![]() ![]() ![]() Group: Members Posts: 2,856 Joined: 17-September 03 From: huntsville, al Member No.: 1,169 Region Association: None ![]() ![]() |
Length from the bell housing flange on the block to the front of the balancer/serpetine pulley: 25.5 inches
from bottom rail of block to highest point on the valve cover 21 inches. I might be sticking this into a stock chassis if it looks possible. |
![]() ![]() |
Brett W |
![]()
Post
#2
|
Advanced Member ![]() ![]() ![]() ![]() Group: Members Posts: 2,856 Joined: 17-September 03 From: huntsville, al Member No.: 1,169 Region Association: None ![]() ![]() |
THis motor is SO tiny. but has the potential for HUGE power. I kinda want to build one more bad ass four just for my blue street car but damn it is hard to argue with 250hp and 260lbft from a stock V8. THAT weighs less than a fully dressed out small block.
I need some one with a fully dressed V8 to measure the length for me. |
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 16th June 2024 - 06:10 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |