 Differential output shaft seal replacement procedure? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Han Solo |
 Jul 31 2015, 10:06 AM
Post
#1
|
|
Member  Group: Members Posts: 291 Joined: 30-September 13 From: Middle Tennessee Member No.: 16,456 Region Association: South East States  |
Looks like the hot weather and fast driving has made a slight leak into one that's creating a bit of a puddle. I found a thread on Rennelist for 924/944...
http://rennlist.com/forums/924-931-944-951...-procedure.html ...but is there one here for 914? Same procedure? Any tips? Thanks gents! |
   |
 
|
  |
Replies
| TravisNeff |
Jul 31 2015, 10:43 AM
Post
#2
|
|
914 Guru Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region 
|
Remove the expansion bolt from the trans flange, and pull out the trans flange. Pull out the seal, I used a pair of pliers and that worked fine. Wipe out the race and tap in the new seal until it bottoms out. Replace the trans flange and torque the expansion bolt back down. That's it!
|
|
|
|
Posts in this topic
Han Solo Differential output shaft seal replacement procedure? Jul 31 2015, 10:06 AM
Travis Neff Procedure is the same, you just want to make sure ... Jul 31 2015, 10:30 AM Han Solo
Procedure is the same, you just want to make sure... Jul 31 2015, 10:33 AM Han Solo
Remove the expansion bolt from the trans flange, ... Jul 31 2015, 10:46 AM BeatNavy I think that's the thread I used as reference.... Jul 31 2015, 10:47 AM JawjaPorsche The expansion bolt from the trans flange is a 19 m... Jul 31 2015, 11:26 AM Dr Evil Tq on bolt is 19 ft/lb. Seal does not bottom out o... Jul 31 2015, 01:46 PM Han Solo Thank you gentlemen. I'll be doing the procedu... Aug 1 2015, 03:54 PM Travis Neff Dr Evil caught me, you aren't supposed to pres... Aug 4 2015, 12:15 PM Dr Evil Ah, the bearing will erode the part touching it ;) Aug 4 2015, 12:40 PM
john77 I'm just about to do this today. Haynes manual... Aug 9 2015, 03:58 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 02:35 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.