 Djet installation sequence, Wanting BTDT experience |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| clapeza |
 Sep 6 2015, 05:56 PM
Post
#1
|
|
Member  Group: Members Posts: 229 Joined: 7-February 11 From: South GA Member No.: 12,677 Region Association: South East States 
 |
I'm in the process of getting rid of the single carb set-up and putting Djet back on my 1970 1.7L. I've rounded up the pieces from helpful members in this group, and I'm on the verge on putting pieces back in the car. None of the original FI components are in the car. Now that the heat index has dropped below 100 F, I might be able to get something done!
Here's what I've done so far: 1) Pulled the fuel tank. Boiled it out, Marine Clean'ed it, etched it with Metal Ready, and sealed it with the POR-15 tank sealer. 2) Got new stainless lines and fuel hoses from Racer Chris, but haven't installed them yet. 3) Cleaned, painted, and lubed most of the parts. 4) Got new gaskets and seals for the intake runners and injectors. What's the best order for putting the parts in place? FI brain first? When to install runners and injectors? When to re-plumb the fuel lines? Reinstall distributor? I'd hate to get deep into it and discover I have to take it all out just because I forgot to connect a vacuum line or ground wire under the plenum... Thanks! |
   |
 
|
  |
Replies
| mepstein |
Sep 6 2015, 07:53 PM
Post
#2
|
|
914-6 GT in waiting Group: Members Posts: 19,952 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region
|
Wire harness 2nd to last. Hoses last.
|
|
|
|
Posts in this topic
clapeza Djet installation sequence Sep 6 2015, 05:56 PM
Mblizzard For me, I install all the fuel rails and intakes o... Sep 6 2015, 07:05 PM The Cabinetmaker Start by installing the throttle body to the plen... Sep 6 2015, 07:21 PM Bob L. I would attach the injector ground wire to the eng... Sep 6 2015, 07:30 PM 914_teener :agree:
also I would add..the MPS is a pain if t... Sep 6 2015, 08:38 PM The Cabinetmaker Ask 14 different people. You'll get 14 differe... Sep 7 2015, 05:39 AM
MichaelB It's nice to have extra room when installing t... Sep 7 2015, 07:43 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 04:19 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.