 What's the best lift for an 8' ceiling garage?, and can i fit one 914 under the other?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DRPHIL914 |
 Dec 7 2015, 08:32 AM
Post
#1
|
|
Dr. Phil  Group: Members Posts: 5,768 Joined: 9-December 09 From: Bluffton, SC Member No.: 11,106 Region Association: South East States 
 |
or even a boxster or an 996?
looking at a move soon and starting to make some plans on how to set up the new garage., so looking for advice: Garage is 30' x 26', more info to come!!! |
   |
 
|
  |
Replies
| Steve |
Dec 8 2015, 07:34 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,606 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California
|
I have a Bendpak MD6xp
http://www.bendpak.com/car-lifts/specialty-lifts/md-6xp.aspx No problem with my 8' garage. I can get to everything except for the floor pan. I had no problems pulling my 3.2 six motor and trans, hell hole repair and re-installation of everything. I have a trashed hydraulic stool on the lowest setting that I roll around on. I am 5'10" and have no problems rolling around under the car to work on it. Night and day better than jack stands and cardboard to lay on. |
 |
|
Posts in this topic
Philip W. What's the best lift for an 8' ceiling garage? Dec 7 2015, 08:32 AM
budk
or eve a boxster or an 996?
looking at a move so... Dec 7 2015, 08:47 AM
GregAmy 8" is pretty small.... :lol:
Yeah, you run t... Dec 7 2015, 09:42 AM jor
8" is pretty small.... :lol:
Yeah, you run ... Dec 7 2015, 01:28 PM Amphicar770 The other challenge you will have is that if your ... Dec 7 2015, 09:41 AM Philip W. o.k, so I corrected the 8" vs 8' misprint... Dec 7 2015, 01:22 PM Elliot Cannon I wish my ceiling was that high. :D Dec 7 2015, 04:05 PM Philip W. went back to the hopefully soon-to-be-mine garage ... Dec 8 2015, 08:11 AM mskala With barely 8', you will have issues to deal w... Dec 8 2015, 09:33 AM tdgray My solution... but it does not sound like you have... Dec 8 2015, 02:42 PM mepstein I like my snap on mid rise lift. I can drive over ... Dec 8 2015, 02:49 PM 74ravenna
I like my snap on mid rise lift. I can drive over... Dec 8 2015, 03:27 PM mepstein
I like my snap on mid rise lift. I can drive ove... Dec 8 2015, 03:45 PM wndsnd Will a mid rise scissor lift allow enough clearanc... Dec 8 2015, 05:26 PM r_towle Yes, but you might want to lift it, set the wheels... Dec 8 2015, 05:28 PM tdgray Mine has a power pack as well...Atlas 6000.
If yo... Dec 8 2015, 05:40 PM wndsnd The adapters are only 6"? Dec 8 2015, 06:50 PM r_towle Can be pretty tall, call Greg smith lifts in New H... Dec 8 2015, 06:51 PM tdgray
Can be pretty tall, call Greg smith lifts in New ... Dec 9 2015, 07:30 AM wndsnd Might take you up on that. All cash going into en... Dec 8 2015, 07:07 PM jim_hoyland Have you thought about going down instead of up ? ... Dec 9 2015, 05:50 PM Philip W.
Have you thought about going down instead of up ?... Dec 9 2015, 06:56 PM wndsnd For general service I think it would be a great id... Dec 9 2015, 06:37 PM 76-914 Since I've been using my lift I've wondere... Dec 11 2015, 09:34 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 02:02 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.