How stong is the stock engine bar, will it a Subaru engine |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
How stong is the stock engine bar, will it a Subaru engine |
tazz9924 |
Jan 15 2016, 09:24 PM
Post
#1
|
Senior Member Group: Members Posts: 703 Joined: 31-May 15 From: Mooresville NC Member No.: 18,779 Region Association: None |
Hello 914 World, im building a suby swap and i have small car engine mounts. i was thinking about modifying the stock engine bar to except the small car mounts but is it strong enough? Also as a side question would it make an intense axle angle with a suby 5 speed?
|
BIGKAT_83 |
Jan 16 2016, 02:16 PM
Post
#2
|
Senior Member Group: Members Posts: 1,798 Joined: 25-January 03 From: Way down south Bogart,GA Member No.: 194 Region Association: South East States |
Mount the bar solid to the engine and then use the 70-72 engine mounts at the ends of the crossbar. This worked super good on the EG33 engine I had in my car to start with.
I made the engine and transaxle mounts in about 4 hrs. If I was doing another Subaru conversion that's the way I would do it. The stock Subaru mounts are way to soft to use without using the stock lateral rear upper mount a Subaru uses. Bob |
Lo-Fi Version | Time is now: 7th June 2024 - 10:17 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |