How stong is the stock engine bar, will it a Subaru engine |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
How stong is the stock engine bar, will it a Subaru engine |
tazz9924 |
Jan 15 2016, 09:24 PM
Post
#1
|
Senior Member Group: Members Posts: 703 Joined: 31-May 15 From: Mooresville NC Member No.: 18,779 Region Association: None |
Hello 914 World, im building a suby swap and i have small car engine mounts. i was thinking about modifying the stock engine bar to except the small car mounts but is it strong enough? Also as a side question would it make an intense axle angle with a suby 5 speed?
|
Chris H. |
Jan 18 2016, 09:48 AM
Post
#2
|
Senior Member Group: Members Posts: 4,032 Joined: 2-January 03 From: Chicago 'burbs Member No.: 73 Region Association: Upper MidWest |
No problem George... I am using Bob's mount which is an early bar that bolts directly to the EG33 with no Subaru engine mounts. It's very simple. I think there is a pic of it in my build thread. There are a couple of very sturdy pieces of iron bolted to the engine bar which are L shaped and then bolt where the engine mounts would normally bolt to. I'll be taking the engine out soon if you want me to measure it. You could definitely make a similar one for your engine, just be slightly different hole placement due to the trans being a little farther forward.
|
Lo-Fi Version | Time is now: 7th June 2024 - 03:53 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |