That'll buff right out ... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
That'll buff right out ... |
SirAndy |
Feb 8 2016, 12:02 AM
Post
#1
|
Resident German Group: Admin Posts: 41,675 Joined: 21-January 03 From: Oakland, Kalifornia Member No.: 179 Region Association: Northern California |
Attached image(s) |
mbseto |
Feb 9 2016, 09:34 AM
Post
#2
|
Senior Member Group: Members Posts: 1,253 Joined: 6-August 14 From: Cincy Member No.: 17,743 Region Association: North East States |
All that sheet metal between the firewalls is available from RD.
Cut everything out between the firewalls, and build a jig to hold the two halves straight. Shouldn't be much greater effort that the dollies many guys build anyway. Get the longs, tunnels, and pans from RD and weld them all up as a unit. Then weld the whole unit in at once. If you take good care with straight edge and square and can test fit the doors during the process, I think it would actually be easier that the usual cut-and-weld-as-you-go process that is usually done. |
Lo-Fi Version | Time is now: 6th June 2024 - 11:25 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |