 AAR Electrical lead, disconnect |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| turk22 |
 Mar 10 2016, 04:50 PM
Post
#1
|
|
Treetop Flyer  Group: Members Posts: 735 Joined: 27-July 12 From: Cincinnati OH Member No.: 14,725 Region Association: Upper MidWest  |
I found that my AAR appears to stuck closed, very poor cold idle, and then idles fine after warm up. I plan to PB blaster the crap out of the AAR and bench test it to make sure it can open and close correctly.
This may be a stupid question, but how is this lead disconnected, is it simply pulled off, or ??   thanks, Turk |
   |
 
|
  |
Replies
| rgalla9146 |
Mar 10 2016, 07:33 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,781 Joined: 23-November 05 From: Paramus NJ Member No.: 5,176 Region Association: None 
|
That blue collar is a crimp-on replacement connector.
It might not survive removal. Solder a replacement on there. |
 |
|
Posts in this topic
turk22 AAR Electrical lead Mar 10 2016, 04:50 PM
porsche913b_sp You don't want to take the wire off it is sold... Mar 10 2016, 05:20 PM Jeff Bowlsby Just disconnect the other end of that red wire whe... Mar 10 2016, 05:36 PM era vulgaris Been a while now since I had my djet car, but IIRC... Mar 10 2016, 05:37 PM pilothyer I have found that in addition to the PB Blaster so... Mar 10 2016, 05:38 PM turk22 ok, I see the connection on the other end. I'm... Mar 10 2016, 05:47 PM Dave_Darling Correct, it's just a spade connection.
--DD Mar 10 2016, 06:18 PM PlantMan I just rebuilt my AAR as it was stuck open too. I ... Mar 10 2016, 06:56 PM turk22 can I use a battery tender to apply the 12v needed... Mar 10 2016, 08:04 PM SLITS Any 12 VDC source will do, but it has to have enou... Mar 10 2016, 08:21 PM turk22 thanks I'll test it that way Mar 10 2016, 09:06 PM jack20 I had the same problem with mine. I soaked it in w... Mar 11 2016, 12:17 AM
turk22 very successful clean and test of the AAR, after f... Mar 12 2016, 06:01 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th July 2025 - 05:21 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.