 What tool do I use to HOLD the pulley, on a 3.6 engine... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| nine14cats |
 Oct 2 2004, 10:38 PM
Post
#1
|
|
Bill Pickering -- 914-6 GT aka....Leeloo  Group: Members Posts: 2,618 Joined: 10-February 03 From: Campbell, CA Member No.: 287 Region Association: None  |
I asked the wrong question before....
What tool holds the crank pulley from moving while I loosen the pulley bolt? Thanks, Bill P. Attached image(s) 
|
   |
 
|
  |
Replies
| nine14cats |
Oct 3 2004, 12:58 AM
Post
#2
|
|
Bill Pickering -- 914-6 GT aka....Leeloo Group: Members Posts: 2,618 Joined: 10-February 03 From: Campbell, CA Member No.: 287 Region Association: None |
It's been said to try an impact wrench. I'll try that tomorrow.
Any other ideas or someone know the wrench I'm looking for. I have the wrench for my former engine, a 74 2.7 litre, but it doesn't work with the 993. Thanks, Bill P. |
|
|
|
Posts in this topic
nine14cats What tool do I use to HOLD the pulley Oct 2 2004, 10:38 PM
Brando there's a special wrench that you use, it goes... Oct 3 2004, 02:31 AM Steve I used a flywheel lock.
It slides over one of the ... Oct 3 2004, 08:13 PM
East coaster Air wrench worked fine for mine. Is that going int... Oct 3 2004, 08:17 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 03:30 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.