 What tool do I use to HOLD the pulley, on a 3.6 engine... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| nine14cats |
 Oct 2 2004, 10:38 PM
Post
#1
|
|
Bill Pickering -- 914-6 GT aka....Leeloo  Group: Members Posts: 2,618 Joined: 10-February 03 From: Campbell, CA Member No.: 287 Region Association: None  |
I asked the wrong question before....
What tool holds the crank pulley from moving while I loosen the pulley bolt? Thanks, Bill P. Attached image(s) 
|
   |
 
|
  |
Replies
| Steve |
Oct 3 2004, 08:13 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,614 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California 
|
I used a flywheel lock.
It slides over one of the trans studs and locks into the starter ring teeth. Steve |
|
|
|
Posts in this topic
nine14cats What tool do I use to HOLD the pulley Oct 2 2004, 10:38 PM
nine14cats It's been said to try an impact wrench. I... Oct 3 2004, 12:58 AM Brando there's a special wrench that you use, it goes... Oct 3 2004, 02:31 AM
East coaster Air wrench worked fine for mine. Is that going int... Oct 3 2004, 08:17 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 11:43 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.