 Help! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| pacman |
 Jun 23 2016, 09:14 PM
Post
#1
|
|
Newbie  Group: Members Posts: 29 Joined: 5-March 16 From: Bend Member No.: 19,732 Region Association: Pacific Northwest  |
Hey guys problem here, i went to change out my speedometer drive and it is frozen into the aluminumn shaft inside the trans. I have tried everything I can to free it up with no luck. Any ideas?
Attached thumbnail(s)  
|
   |
 
|
  |
Replies
| bdstone914 |
Jun 23 2016, 09:54 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 5,269 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(pacman @ Jun 23 2016, 08:14 PM)  Hey guys problem here, i went to change out my speedometer drive and it is frozen into the aluminumn shaft inside the trans. I have tried everything I can to free it up with no luck. Any ideas? I can sell you one of 914Rubbers new improved ones with two o-rings for $60 or a used one for $15 shipped. Would have been easier to break that nut loos while it was still in the trans where it is held in place by the bolt. |
|
|
|
| pacman |
Jun 24 2016, 12:09 AM
Post
#3
|
|
Newbie Group: Members Posts: 29 Joined: 5-March 16 From: Bend Member No.: 19,732 Region Association: Pacific Northwest |
QUOTE(bdstone914 @ Jun 23 2016, 09:54 PM) QUOTE(pacman @ Jun 23 2016, 08:14 PM) Hey guys problem here, i went to change out my speedometer drive and it is frozen into the aluminumn shaft inside the trans. I have tried everything I can to free it up with no luck. Any ideas? I can sell you one of 914Rubbers new improved ones with two o-rings for $60 or a used one for $15 shipped. Would have been easier to break that nut loos while it was still in the trans where it is held in place by the bolt. I appreciate the offer! Might end up taking you up on that if i cannot get it unfrozen. I tried it in the tranny but because of a stupid mistake cracked a little bit of the case around the thread so cant do that because of risk /: |
|
|
|
Posts in this topic
pacman Help! Jun 23 2016, 09:14 PM
Jeffs9146 PB Blaster over night then use a large pair of cha... Jun 23 2016, 09:44 PM
pacman
PB Blaster over night then use a large pair of ch... Jun 24 2016, 12:10 AM r_towle Get a gallon of carb cleaner and dunk it for about... Jun 24 2016, 12:28 AM Jeffs9146 Look at the photos in this link to see the bolt th... Jun 24 2016, 11:17 AM pacman Thanks guys! Ended up getting it free with a s... Jun 25 2016, 11:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 13th March 2026 - 11:26 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.