 How to remove axle from rear control arm, Rear Control Arm |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kaiserms |
 Oct 28 2016, 09:52 PM
Post
#1
|
|
MSKaiser  Group: Members Posts: 26 Joined: 8-September 16 From: waterford, michigan Member No.: 20,378 Region Association: Upper MidWest  |
[size=6]
I removed the rear swing axles from my '73 914 to replace the bushings & wheel bearing and have powder coated. I have torched out 95% of the old rubber bushings but still can't budge the axle that goes through the center of the control arm. Do I need a stronger torch? Been using small cannister camp stove for torch fuel. Need some clear advice, Thanks, Kaiser |
   |
 
|
  |
Replies
| kaiserms |
Oct 30 2016, 01:59 AM
Post
#2
|
|
MSKaiser Group: Members Posts: 26 Joined: 8-September 16 From: waterford, michigan Member No.: 20,378 Region Association: Upper MidWest |
BD,
I keep trying to say thanks. Can't get this message system wired. Question: Did you double nut the 14" shaft onto the existing threads of the bolt in the control arm? Kaiser |
|
|
|
Posts in this topic
kaiserms How to remove axle from rear control arm Oct 28 2016, 09:52 PM
bdstone914
[font=Arial]
I removed the rear swing axles fro... Oct 28 2016, 10:11 PM bdstone914 I put a open end lug nut on the pivot shaft to kep... Oct 30 2016, 06:49 AM bdstone914 I just saw you are from Waterford MI. That is wher... Oct 30 2016, 06:55 AM kaiserms It is Bruce, right?
Ok, guess that makes sense no... Oct 30 2016, 05:00 PM
Amphicar770 If you burn out enough of the bushing the shaft wi... Oct 31 2016, 08:29 AM kaiserms
If you burn out enough of the bushing the shaft w... Oct 31 2016, 12:53 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 07:03 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.