 How to remove axle from rear control arm, Rear Control Arm |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kaiserms |
 Oct 28 2016, 09:52 PM
Post
#1
|
|
MSKaiser  Group: Members Posts: 26 Joined: 8-September 16 From: waterford, michigan Member No.: 20,378 Region Association: Upper MidWest  |
[size=6]
I removed the rear swing axles from my '73 914 to replace the bushings & wheel bearing and have powder coated. I have torched out 95% of the old rubber bushings but still can't budge the axle that goes through the center of the control arm. Do I need a stronger torch? Been using small cannister camp stove for torch fuel. Need some clear advice, Thanks, Kaiser |
   |
 
|
  |
Replies
| bdstone914 |
Oct 30 2016, 06:55 AM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,543 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
I just saw you are from Waterford MI. That is where i grew up. Not nany 914s left around there.
So we are like 914 brothers. LOL |
|
|
|
Posts in this topic
kaiserms How to remove axle from rear control arm Oct 28 2016, 09:52 PM
bdstone914
[font=Arial]
I removed the rear swing axles fro... Oct 28 2016, 10:11 PM kaiserms BD,
I keep trying to say thanks. Can't get th... Oct 30 2016, 01:59 AM bdstone914 I put a open end lug nut on the pivot shaft to kep... Oct 30 2016, 06:49 AM kaiserms It is Bruce, right?
Ok, guess that makes sense no... Oct 30 2016, 05:00 PM
Amphicar770 If you burn out enough of the bushing the shaft wi... Oct 31 2016, 08:29 AM kaiserms
If you burn out enough of the bushing the shaft w... Oct 31 2016, 12:53 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 06:53 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.