 can't stop the leak |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ruddyboys |
 Oct 23 2004, 12:36 PM
Post
#1
|
|
Hummel eigentümer  Group: Members Posts: 595 Joined: 3-March 04 From: Monroe, NY Member No.: 1,749 Region Association: North East States  |
I tried replacing the O-rings 3 times, and still a leak. After running the car for about 10 min smpke starts to bellow out of the engine compartment. Problem I have old heads that have smaller push rid tubes and I am not about to send them out to be bored and buy new tubes. Would there be a problem with cleaning the area real good and using some kind of high temp silicon or such around the outside of the tubes and heads to stop the leak.
|
   |
 
|
  |
Replies
| Joe Ricard |
Oct 23 2004, 06:21 PM
Post
#2
|
|
CUMONIWANNARACEU Group: Members Posts: 6,811 Joined: 5-January 03 From: Gautier, MS Member No.: 92 |
Well, I know what a pain this is. here is what I did and it seamed to work pretty good. Are you leaking at the case or head? After reading it seems like the head side???
Yes, Cleaning REALLY good with scotch bright pad or burnishing wheel on a dremel gets all the crap out. the sealing surface must be really smooth. the groove in the tube must be round and clean too. Go to home center and get white plumbers paste. Put a little on each O-ring. Tubes should slide right in (maybe a little shove). if ya gots to bang them in somethings wrong and the o-ring is rolling or getting cut. Found out the hard way about different size tubes for early 1.7L motors. |
|
|
|
Posts in this topic
ruddyboys can't stop the leak Oct 23 2004, 12:36 PM
Rich Bontempi We have some of the correct push rod tube o-rings ... Oct 23 2004, 12:42 PM ruddyboys Rich, I tried the right rings and it still leaks, ... Oct 23 2004, 01:13 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 10:02 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.