 oh where oh where, have my 4th and 5th gears gone |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BahnBrenner914 |
 Oct 24 2004, 12:10 PM
Post
#1
|
|
The girl is gone and all I have now is a beat-up teener  Group: Members Posts: 301 Joined: 22-May 04 From: Gig Harbor and University Place, WA :: School in Angola, IN :: girlfriend in Sarasota, FL Member No.: 2,094 Region Association: None  |
i know there is another topic on right now about this but my situation is kind of different. i have been having trouble with my sideshift tranny since i got the car a year ago. we pulled out the tranny and everything worked, we could engage all the gears and they spun around just fine so we put the tranny back in but i was still having problems. i replaced the ball cup bushing at the tranny and adjusted the linkage until i could get all the gears just fine. i can shift it into 4th and 5th from the tranny and the stick inside the car and it is engaged. But when i put it on jacks and ran it 4th and 5th didn't put any power through, the engine just revved and the speedo fell back down. somebody help me out here. thanks
|
   |
 
|
  |
Replies
| Joe Ricard |
Oct 24 2004, 01:19 PM
Post
#2
|
|
CUMONIWANNARACEU Group: Members Posts: 6,811 Joined: 5-January 03 From: Gautier, MS Member No.: 92 |
(IMG:style_emoticons/default/agree.gif)
You might also ckeck for a tight fit at the coupling of the 2 shift rods. if the cone screw is not tight or the hole is sloppy you are not rotating the aft rod far enough to select 4-5 gear. Or you did not get the shifter lined back up on the front rod . Getting tis right is a pain. 1. undo all 3 bolts that hold the shifter to the tunnel 2. use a thin vise/narrow grip to hold the shift rod 3. loosen the binder bolt on the shifter 4. rotate the the rod left one spline at a time till you get your gears to select. Yes this is trial and error. |
|
|
|
Posts in this topic
BahnBrenner914 oh where oh where Oct 24 2004, 12:10 PM
Bleyseng Mis-aligned shiftlinkage or at the forks.
Geoff Oct 24 2004, 12:42 PM BahnBrenner914 yeah i'm pretty sure the shift linkage is all ... Oct 26 2004, 05:40 PM
ClayPerrine From Experience... Take the gear stack out of the ... Oct 27 2004, 07:21 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 06:36 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.