 rear targa latch adjustment... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| scottb |
 May 12 2003, 05:10 PM
Post
#1
|
|
who wants a PEZ?!  Group: Members Posts: 1,993 Joined: 27-December 02 From: south-(not north)-wick, MA Member No.: 32 Region Association: North East States  |
the rear passenger side latch is a bit loose. it doesn't pull the top down firmly enough to set the seal. drivers side is the same but not as loose. just got done looking through haynes and they only talk about adjusting the front. any suggestions on firming up the back latches? since it never seems to stop raining here, i gotta seal the little money pit up and drive in the wet or just stare at it in the garage.
thanks....... (IMG:style_emoticons/default/driving.gif) |
   |
 
|
  |
Replies
| Dave_Darling |
May 13 2003, 11:32 AM
Post
#2
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California 
|
As noted in the similar thread on the Pelican BBS, the most popular fix is to put something on either the pegs on the roof, or over the hooks on the latches. Electronics shrink tubing is one option, surgical tubing is another, and I'm sure other people have used other stuff as well.
--DD |
|
|
|
Posts in this topic
scottb rear targa latch adjustment... May 12 2003, 05:10 PM
airsix Replace the worn out seal. ;)
-Ben M. May 12 2003, 05:17 PM Aaron Cox but that is too ezpensive! May 12 2003, 05:21 PM scottb shoulda said the seal is new......
now what? May 12 2003, 05:33 PM Aaron Cox i have a bad rear seal. but my pass side rear targ... May 12 2003, 09:00 PM Brad Roberts ScottB,
I have seen the actual lever arm get "exp... May 12 2003, 10:41 PM Lawrence914-6 There are aftermarket seals out there... probably ... May 13 2003, 06:14 AM scottb thanks guys. appreciate the input. i will take a... May 13 2003, 03:03 PM Brad Roberts There is NO way shrink tubing will last more than ... May 13 2003, 03:07 PM Part Pricer I have plastic tubing like the kind that they use ... May 13 2003, 03:11 PM
Brad Roberts Do you have a pic ?? I normally have enough pieces... May 13 2003, 03:12 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 03:02 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.