 Anybody cutting up a car? I need a part, non-rusty please |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Qarl |
 Oct 25 2004, 08:18 PM
Post
#1
|
|
Shriveled member  Group: Benefactors Posts: 5,233 Joined: 8-February 03 From: Florida Member No.: 271 Region Association: None   |
I need the center part of the firewall/backpad area...
Almost all of it, to just a few inches above the crease in the bottom, and wrapping around the sides towards the seat back recesses. As in the picture below... I need this to be rust-free. Will pay reasonable fee for your effort plus shipping expenses to Orlando, FL. Thanks... Attached image(s) 
|
   |
 
|
  |
Replies
| ThinAir |
Oct 25 2004, 08:25 PM
Post
#2
|
|
Best friends Group: Members Posts: 2,564 Joined: 4-February 03 From: Flagstaff, AZ Member No.: 231 Region Association: Southwest Region 
|
I'm getting ready to cut the center tunnel out of my parts car so I can repair my clutch tube. I'll need part of the firewall at the bottom, but this section should be available. How soon do you need it? I've got my sawzall, but I've never cut one before so I'm a little slow at getting started (I want to cut it so that I maximize the parts that are left).
|
|
|
|
Posts in this topic
Qarl Anybody cutting up a car? I need a part Oct 25 2004, 08:18 PM
Headrage If you need the drivers side, let me know! Oct 25 2004, 08:20 PM Qarl Driver's side? I need the hump in the center,... Oct 25 2004, 08:24 PM Qarl Not for a week or two... I don't need below w... Oct 25 2004, 08:37 PM Qarl I drew an arrow to the crease in the photo above a... Oct 25 2004, 08:40 PM ws91420 Try these guys dC automotive Oct 25 2004, 08:41 PM Qarl Yeah, I know about them and other similar places.
... Oct 25 2004, 08:42 PM Qarl Oh, and that's not my car... just a "reference... Oct 25 2004, 08:43 PM morphenspectra just cut up a 71.
i got that piece laying in the b... Oct 25 2004, 08:52 PM
vsg914 I gots one Karl. just need to cut it out. I think ... Oct 25 2004, 08:54 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 07:51 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.