 Gearbox input shaft seal installation? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| falcor75 |
 Apr 1 2017, 07:51 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,579 Joined: 22-November 12 From: Sweden Member No.: 15,176 Region Association: Scandinavia 
 |
How deep should it be installed? Flush with the outer flange or flush with the inner flanfe??
|
   |
 
|
  |
Replies
| BeatNavy |
Apr 1 2017, 10:11 AM
Post
#2
|
|
Certified Professional Scapegoat Group: Members Posts: 2,955 Joined: 26-February 14 From: Easton, MD Member No.: 17,042 Region Association: MidAtlantic Region
|
The primary goal is to just get the seal deep enough so that it doesn't interfere with the tube when mounted back onto the case. The way you check that: if the seal's opening starts to distort at any point while you're installing that tube, the seal needs to go deeper. If it does not distort, and the tube mounts cleanly then, in the words of Dr. Evil "you're golden, be happy."
Stock seals had a shoulder that sat on the lip of the opening, but most replacements do not, I believe. |
 |
|
Posts in this topic
falcor75 Gearbox input shaft seal installation? Apr 1 2017, 07:51 AM
falcor75 RE: Gearbox input shaft seal installation? Apr 1 2017, 07:52 AM forrestkhaag In order to seal properly, (and I just did mine a ... Apr 1 2017, 09:41 AM
mtndawg
The primary goal is to just get the seal deep eno... Apr 1 2017, 04:08 PM BeatNavy
The primary goal is to just get the seal deep en... Apr 1 2017, 05:05 PM porschetub Had this tool from VW days perfect for installing ... Apr 1 2017, 01:57 PM 914Sixer I can add a picture of what the seal looks like. ... Apr 1 2017, 09:26 PM BeatNavy Here's a couple of pics of the type Mark got a... Apr 2 2017, 08:00 AM falcor75 Well I got a pretty obvious signal from the gearbo... Apr 22 2017, 10:08 AM Bartlett 914
Well I got a pretty obvious signal from the gearb... Apr 22 2017, 05:02 PM dangrouche I would always smear of lube to prevent tearing of... Apr 22 2017, 10:22 AM falcor75 I made a tool that will work, lasercut a washer th... Apr 22 2017, 10:50 AM The Cabinetmaker You must clean and smooth the inside of the case. ... Apr 23 2017, 07:50 AM falcor75 Car is back together and testdriven around 20 km. ... Apr 23 2017, 08:42 AM SteveNMaine Can you use the guide tube to press in the seal? May 6 2025, 07:08 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th November 2025 - 06:53 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.