 Welding Jack Posts, A little help with configuring |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Deano |
 Oct 26 2004, 06:01 PM
Post
#1
|
|
Member  Group: Members Posts: 83 Joined: 13-October 04 From: Des Moines, Iowa Member No.: 2,942  |
I am in the process of repairing the longs on my car, pretty straight forward, except the jack posts had been removed by the PO. I have the replacement pieces and am not sure of proper set up. How far into the support should the tube go? Do I weld the tube to the support first, then to the car? Does the tube get welded to the car or just to the support? HELP!!!!! All of the photos and illustrations I can find really don't help.
|
   |
 
|
  |
Replies
| balljoint |
Oct 26 2004, 07:08 PM
Post
#2
|
|
914 Wizard Group: Members Posts: 10,001 Joined: 6-April 04 Member No.: 1,897 Region Association: None |
Measurements to indicate location might also be usefull.
|
|
|
|
Posts in this topic
Deano Welding Jack Posts Oct 26 2004, 06:01 PM
Porsche Rescue I want to know too. Oct 26 2004, 06:07 PM ejm Best way to locate the tube is to use the hole in ... Oct 26 2004, 07:49 PM Deano That's nice to know, I would have never though... Oct 26 2004, 08:01 PM mercdev 1 view (both right side) Oct 26 2004, 08:37 PM mercdev 2nd Oct 26 2004, 08:37 PM Deano Great Pix. Thanks that helps a lot. When your oute... Oct 26 2004, 09:11 PM mercdev 
Deano Excellent, thanks to everyone again. Your help is ... Oct 26 2004, 09:59 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 09:50 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.