 Rust Repair on Front Trunk Channel |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Nacho |
 Apr 16 2017, 03:24 PM
Post
#1
|
|
Member  Group: Members Posts: 222 Joined: 31-December 16 From: So. California Member No.: 20,716 Region Association: None 
 |
Hi All,
I've been searching for days now and I can't seem to find much on how to rust repair or weld in new pieces of the front trunk seal channel. Specifically the nose area. Here is my issue. Thanks  |
   |
 
|
  |
Replies
| 914dave |
Apr 17 2017, 06:43 AM
Post
#2
|
|
914 Addict Group: Members Posts: 740 Joined: 19-October 03 From: Willow Grove Pa. Member No.: 1,262 Region Association: North East States 
|
Mine were rusty too. I cut off the old and bent up new channel. Then I used an Eastwood shrinker/stretcher to form the radii. Turned out pretty good. Can't tell they were replaced. Don't have pics on my phone. Can get some tonightnoff turbo/c if you'd like.
|
|
|
|
Posts in this topic
Nacho Rust Repair on Front Trunk Channel Apr 16 2017, 03:24 PM
mgphoto I had an accident and uncovered a lot of rust, I d... Apr 16 2017, 08:19 PM
Nacho
I had an accident and uncovered a lot of rust, I ... Apr 16 2017, 10:32 PM
billium01
I had an accident and uncovered a lot of rust, I ... Apr 16 2017, 10:38 PM mgphoto
I had an accident and uncovered a lot of rust, I... Apr 17 2017, 06:55 PM mepstein I think restoration design sellls the channel. Ask... Apr 17 2017, 04:26 AM Nacho
I think restoration design sellls the channel. As... Apr 17 2017, 08:31 AM Nacho
Mine were rusty too. I cut off the old and bent u... Apr 17 2017, 08:32 AM Perry Kiehl I've been working on this too. Just remember ... Apr 17 2017, 10:08 AM aggiezig I replaced pieces of mine with patches I created. ... Apr 17 2017, 06:09 PM Nacho
I replaced pieces of mine with patches I created.... Apr 17 2017, 08:28 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 04:17 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.