Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> fan flange removal
JFG
post May 29 2017, 11:22 AM
Post #1


Senior Member
***

Group: Members
Posts: 686
Joined: 7-April 16
From: Wales
Member No.: 19,869
Region Association: None



I tried to remove the fan flange so that i can replace the seal behind it but it hasn't budged.

Is there a knack to removing this? Is it safe to fix the puller straigjt onto the flange or is it too brittle?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
iankarr
post May 29 2017, 11:56 AM
Post #2


The wrencher formerly known as Cuddy_K
****

Group: Members
Posts: 2,480
Joined: 22-May 15
From: Heber City, UT
Member No.: 18,749
Region Association: Intermountain Region



Are you referring to the fan hub? If so, after you take out the center bolt, you can take some super thick washers or thick metal stock and place between the hub and case under all three fan bolt holes. Make sure the metal overlaps the case by a good amount. Put the bolts back in (without the fan) and slowly tighten them equally against the washers/metal (kind of like a steering wheel puller) until the hub pops. And pop it will. Make sure you don't lose the woodruff key when it pops. Use some cloth as a catch all. If you use washers, make sure they're at least 3/16 thick so they don't bend or allow the bolt to pierce through and damage the case.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 7th June 2024 - 07:20 PM