Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Fuse blows and alternator light comes on...., 400 miles from home and need to find short circuit....
second wind
post Jun 4 2017, 11:58 AM
Post #1


Senior Member
***

Group: Members
Posts: 857
Joined: 30-December 10
From: Los Angeles, California
Member No.: 12,543
Region Association: Southern California



Hey Gang, had a great WCR and everything was going just great......then my starter wouldn't even turn on but a 914 guru here found the broken yellow wire on my hot start relay and all was well. Then just admiring how my car is all fixed the alternator light goes on and number 8 fuse blows. I had this happen before due to short behind speedo so I jiggled speedo and put in new fuse and all fine again.....until I blipped throttle and fuse blew. Then when I was replacing fuse with engine on I could see the fuse starting to blow and engine seemed to die a bit so I pulled fuse out before it blew. Down to four fuses left. Previous forums say check the fuse panel for short on fuses 8 and 9 terminals hitting dash frame or something like that. Please offer explanations as desert is no place for a breakdown.....thank you!
gg
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
Mike Bellis
post Jun 4 2017, 02:38 PM
Post #2


Resident Electrician
*****

Group: Members
Posts: 8,345
Joined: 22-June 09
From: Midlothian TX
Member No.: 10,496
Region Association: None



See if there is a single spade terminal or multiple. Try to disconnect wires and isolate the issue.

Wish I was closer...
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
second wind
post Jun 4 2017, 03:26 PM
Post #3


Senior Member
***

Group: Members
Posts: 857
Joined: 30-December 10
From: Los Angeles, California
Member No.: 12,543
Region Association: Southern California



QUOTE(Mike Bellis @ Jun 4 2017, 01:38 PM) *

See if there is a single spade terminal or multiple. Try to disconnect wires and isolate the issue.

Wish I was closer...

I found an extremely loose spade connector on fuse 9....hope that is it. Could that be it? Thanks
gg
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
second wind
post Jun 4 2017, 03:58 PM
Post #4


Senior Member
***

Group: Members
Posts: 857
Joined: 30-December 10
From: Los Angeles, California
Member No.: 12,543
Region Association: Southern California



QUOTE(second wind @ Jun 4 2017, 02:26 PM) *

QUOTE(Mike Bellis @ Jun 4 2017, 01:38 PM) *

See if there is a single spade terminal or multiple. Try to disconnect wires and isolate the issue.

Wish I was closer...

I found an extremely loose spade connector on fuse 9....hope that is it. Could that be it? Thanks
gg

That didnt work....changed out connector and fuse blew instantly.....hmmm
gg
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
second wind
post Jun 4 2017, 04:17 PM
Post #5


Senior Member
***

Group: Members
Posts: 857
Joined: 30-December 10
From: Los Angeles, California
Member No.: 12,543
Region Association: Southern California



QUOTE(second wind @ Jun 4 2017, 02:58 PM) *

QUOTE(second wind @ Jun 4 2017, 02:26 PM) *

QUOTE(Mike Bellis @ Jun 4 2017, 01:38 PM) *

See if there is a single spade terminal or multiple. Try to disconnect wires and isolate the issue.

Wish I was closer...

I found an extremely loose spade connector on fuse 9....hope that is it. Could that be it? Thanks
gg

That didnt work....changed out connector and fuse blew instantly.....hmmm
gg


Fixed it!! Reverse light switch wires where grounding out on starter housing....cut them clean trying to fix reverse lights but never taper them off.....they finally worked there way to the starter housing....thanks for the help and now ready to take on 400 mile drive home.....WooooHooooo!!
gg
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 8th June 2024 - 02:59 PM