 How do I get this damned switch out |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| lawrencedesigns |
 Oct 30 2004, 10:46 AM
Post
#1
|
|
Newbie  Group: Members Posts: 36 Joined: 14-July 04 From: West Hills, CA Member No.: 2,349  |
In trying to replace my starter switch, I have run into a snag. Pelican tells me there should be two screws holding the key mechanism in. In my 76, there is no such screws...
How do I get this mechanism out without destroying it? Attached image(s) 
|
   |
 
|
  |
Replies
| ejm |
Oct 30 2004, 10:54 AM
Post
#2
|
|
I can see the light at the end of the tunnel Group: Members Posts: 2,693 Joined: 3-February 03 From: Massachusetts Member No.: 224 Region Association: None |
The lock is held in by a springy tab. If if has never been changed before you'll need to drill a hole in the housing to push on the tab. Look at the new lock cylinder and use it as a guide for the hole location.
|
 |
|
Posts in this topic
lawrencedesigns How do I get this damned switch out Oct 30 2004, 10:46 AM
Root_Werks Your 76 is "newer" or different than the pre 74... Oct 30 2004, 10:49 AM lawrencedesigns Thanks Ed. Unfortunately, I don't have a new ... Oct 30 2004, 11:04 AM vsg914 Keith, before you start drilling holes, check this... Oct 30 2004, 11:18 AM Aaron Cox i know how on a 73/74 car...but that dunt help :( Oct 30 2004, 12:27 PM Cloudbuster Just did this last week on a '75.
Remove the ... Oct 30 2004, 04:30 PM lawrencedesigns Thanks...I got it apart.
I drove over to Performan... Oct 30 2004, 06:59 PM
Cloudbuster The cheap switch works. But not as well as the ex... Oct 30 2004, 11:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 03:55 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.