Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Fuel injector gone bad
troth
post Jun 21 2017, 09:28 PM
Post #1


Member
**

Group: Members
Posts: 160
Joined: 17-August 16
From: CT/WA
Member No.: 20,305
Region Association: None



Vehicle was running great until I lost cylinder no. 2! Verified spark was good. Hmmm... must not be getting fuel. Swapped injectors with one of the good cylinders and was happy to see the issue moved with the injector.

I guess I'm going to shell out to have them all cleaned again. Even though I just did that less than 3000 miles ago. I say all because when I unplugged the injectors individually with the motor idling, each had varying effects on how it ran. So some of the others in addition to no. 2 may also be dirty?

But what could have caused them to go bad all of a sudden? One day it was good, but then the next day when I go to take it to work it's crap. I have read that letting the fuel level get too low can dislodge crud in the tank. It had about 3 gallons in it last time it was running well and it has certainly ran on less fuel than that before. Should the filter be replaced? Is it worth taking the tank out and cleaning it?

Lots of questions, but I am happy the immediate issue presented itself so quickly. I'm just trying to diagnose the root cause to avoid another $100 injector cleaning/test.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
stinkindiesel
post Jul 3 2017, 04:23 PM
Post #2


Member
**

Group: Members
Posts: 184
Joined: 14-June 13
From: Georgetown, TX
Member No.: 16,012
Region Association: Southwest Region



Keep in mind that measuring voltage on a circuit that uses a resistor to drop the voltage will measure the full voltage when open circuit, but will measure correctly under load. It's entirely possible you measured 12V on the injector wiring with the injector unplugged. Remember, no current flow, no voltage drop.

Gary
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 9th May 2025 - 04:24 PM