 Subaru 2wd blanking plate drawing |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| nick1973 |
 Jul 10 2017, 06:38 AM
Post
#1
|
|
Newbie  Group: Members Posts: 6 Joined: 29-April 15 From: Doncaster in the sunny uk Member No.: 18,678 Region Association: None  |
Hello has anyone got a drawing of the blanking plate for the trans I want to get one laser cut is not ill start drawing one up
thanks nick |
   |
 
|
  |
Replies
| rnellums |
Jul 10 2017, 09:59 AM
Post
#2
|
|
Professional Enthusiast Group: Members Posts: 1,673 Joined: 26-November 09 From: Littleton, CO Member No.: 11,072 Region Association: Rocky Mountains |
I have a few of these left from a run I did a while ago. I was asking 40$ for them, laser cut from aluminum. Not sure if shipping to UK would be cost prohibitive though!
-Ross |
|
|
|
| JRust |
Jul 10 2017, 03:26 PM
Post
#3
|
|
914 Guru Group: Members Posts: 6,317 Joined: 10-January 03 From: Albany Oregon Member No.: 129 Region Association: Pacific Northwest 
|
QUOTE(rnellums @ Jul 10 2017, 08:59 AM)  I have a few of these left from a run I did a while ago. I was asking 40$ for them, laser cut from aluminum. Not sure if shipping to UK would be cost prohibitive though! -Ross I have one of Ross setup's. Good setup at a great price. I doubt shipping would be to bad for it. I have seen other guys just cut some diamond plate if it is. Pretty simple with the rear diff cone for a template. |
|
|
|
Posts in this topic
nick1973 Subaru 2wd blanking plate drawing Jul 10 2017, 06:38 AM
76-914 Just use the rear cover as a template and drill gu... Jul 10 2017, 08:55 AM Keyser Sose That's what I did, that or a gasket. Then cut... Jul 10 2017, 08:58 AM
mepstein
That's what I did, that or a gasket. Then cu... Jul 10 2017, 09:57 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th December 2025 - 05:29 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.