 914-6 engine build |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| car guy |
 Aug 22 2017, 11:21 PM
Post
#1
|
|
Newbie  Group: Members Posts: 9 Joined: 25-July 17 From: Houston, Texas Member No.: 21,283 Region Association: None  |
Hey guys,
Having a hard time finding nice cams for my 914-6 2.0L engine build, I was told that 2.7L cams would work. Does anyone have knowledge about this? |
   |
 
|
  |
Replies
| car guy |
Aug 23 2017, 08:34 AM
Post
#2
|
|
Newbie Group: Members Posts: 9 Joined: 25-July 17 From: Houston, Texas Member No.: 21,283 Region Association: None |
The cams were badly damaged and can't be used so I am forced to find alternatives. I went with a forged aluminum 82.5mm piston. Looking to build a good all around motor. I appreciate all the advice and will reach out to some of those guys, thanks.
|
|
|
|
| raynekat |
Aug 23 2017, 08:48 AM
Post
#3
|
|
Advanced Member Group: Members Posts: 2,171 Joined: 30-December 14 From: Coeur d'Alene, Idaho Member No.: 18,263 Region Association: Pacific Northwest 
|
QUOTE(car guy @ Aug 23 2017, 07:34 AM)  The cams were badly damaged and can't be used so I am forced to find alternatives. I went with a forged aluminum 82.5mm piston. Looking to build a good all around motor. I appreciate all the advice and will reach out to some of those guys, thanks. What is the compression ratio of your piston/cylinder? Also what kind of valve pockets are there? These things will also dictate your cams... Lots of good advise in previous posts. |
|
|
|
Posts in this topic
car guy 914-6 engine build Aug 22 2017, 11:21 PM
yellow75 I would talk to Henry Schmitt at Super Tech in CA. Aug 23 2017, 05:30 AM Luke M
Hey guys,
Having a hard time finding nice cams f... Aug 23 2017, 05:47 AM
Mark Henry
Hey guys,
Having a hard time finding nice cams ... Aug 23 2017, 06:51 AM GeorgeRud The 2.7 cams were designed for CIS injection and a... Aug 23 2017, 08:13 AM flyer86d In my opinion.... if you want to do a minimal amou... Aug 23 2017, 08:47 AM car guy The heads are factory and the piston I is 9.5.1 I... Aug 23 2017, 05:41 PM 6freak
Hey guys,
Having a hard time finding nice cams f... Aug 24 2017, 10:39 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th March 2026 - 08:17 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.