Electrical installation questions, Various issues under one thread Options

[JFG]

I'm now in a position to test the electricals on my car. It came with many things missing & broken.

I'm running twin carbs so there'll be no injection specific issues with electrics.

To start I have the following;

Wiring up the reverse light switch. I have used separate bullet connectors (part of the missing category) but I don't know if there is a right/wrong way to insert them. For example, is there a way to look on the switch to see which is live/earth?

There are 2 gauges where the lights don't illuminate. The rev counter and the multi gauge. The Speedo lights up fine. Bulbs and sockets are all new.

When I turn the ignition on the passenger side headlight opens up halfway, does not illuminate until I pull the light switch and does not raise or lower from this position.

Finally (for now) I only have one movement on the wiper switch. This came with the ignition cowl as a once piece lot.

I'll post some pictures shortly.

[DM_2000]

13.3 is on the lower end of scale but still OK, especially if the battery is discharged and the alternator is working to recharge.

What starter terminal did you use for the yellow trigger wire?