Frame stiffener install?, Jack receiver plate needed? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Frame stiffener install?, Jack receiver plate needed? |
jet1 |
Nov 6 2004, 11:06 AM
Post
#1
|
Member Group: Members Posts: 311 Joined: 16-June 04 From: Accord,NY Member No.: 2,213 Region Association: North East States |
Hi all,
I am installing the frame stiffners from Restoration Design on my '73. do i need to install the jack receiver plate first or does the part on the stiffner replace it? any advice or tips for the install are welcome. BTW does anyone know if Restoration design has the lower wheelhouse P331 in stock? or will I have to wait for a production run? Thanks, Keith Attached image(s) |
jet1 |
Nov 6 2004, 08:06 PM
Post
#2
|
Member Group: Members Posts: 311 Joined: 16-June 04 From: Accord,NY Member No.: 2,213 Region Association: North East States |
I am doing massive amounts of rust repair so I have already cut part of the rear quarter panel away for access. I will be replacing the outer long first, then installing the overlay.
I am going to por the inside of the long. does anyone have any ideas on rust protection for the area that is under the overlay? should I put the overlay over bare metal then por the out side? or should I use weldable primer? or...? |
Lo-Fi Version | Time is now: 1st June 2024 - 05:53 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |