 rocker cover panels |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| JFG |
 Apr 20 2018, 02:51 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 686 Joined: 7-April 16 From: Wales Member No.: 19,869 Region Association: None  |
I started to refurb mine tonight. The picture below shows the only 2 fittings that i have with them.
As i lost the tear down pictures i don't have a source of info to refit them and what is used. Does any of the usual suppliers make a fitting kit for these? How do they attach in between the screws shown? Finally are these covers meant to have a slight turn/twist in them towards the rear?  |
   |
 
|
  |
Replies
| mepstein |
Apr 20 2018, 05:51 PM
Post
#2
|
|
914-6 GT in waiting Group: Members Posts: 19,325 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region 
|
Fuel hose will do in a pinch. Also, plastic or aluminum rivets are easier to drill out to inspect the rockers. I’m told that’s why the factory used plastic. Cut them off with a knife. 914rubber has them.
|
 |
|
Posts in this topic
JFG rocker cover panels Apr 20 2018, 02:51 PM
sholman5 The rubber acts as a spacer between the cover at b... Apr 20 2018, 04:07 PM sholman5 RE: rocker cover panels Apr 20 2018, 04:17 PM sholman5 Rivots were factory.Aluminum. Most people just use... Apr 20 2018, 04:31 PM jcd914 It seems to me 914rubber had a kit with the rubber... Apr 20 2018, 05:31 PM rgalla9146 The hardware shown is correct for the ends. Not sh... Apr 20 2018, 07:35 PM porschetub I put spacers under the lower mounting bolts, hard... Apr 20 2018, 08:26 PM JFG Thanks for the info. I'll get on to mark for f... Apr 20 2018, 11:32 PM
saigon71 I used small stainless steel screws to attach my r... Apr 22 2018, 05:28 AM Big Len
I used small stainless steel screws to attach my ... Apr 22 2018, 05:35 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 05:05 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.