 What I did today, Removed tar from interior floorboards |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| watsonrx13 |
 Nov 21 2004, 06:02 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,734 Joined: 18-February 03 From: Plant City, FL Member No.: 312 Region Association: South East States  |
Well it was a perfect day in sunny Florida (finally) so I decided to get some work done on the teener. Today the objective was to remove the tar from the interior floorboards.
Here's the before pic: 1 of 4 Attached image(s) 
|
   |
 
|
  |
Replies
| watsonrx13 |
Nov 21 2004, 06:39 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,734 Joined: 18-February 03 From: Plant City, FL Member No.: 312 Region Association: South East States |
No, it was very clean, but since I was in there...
Once I finish with the interior, I'm going back over the engine compartment and rear trunk to check anything I might have missed. Then I'm going to paint these areas, looking at end of Dec/early Jan. Anyway, that's the plan for now (subject to change without prior notification... (IMG:style_emoticons/default/wacko.gif) ) |
|
|
|
Posts in this topic
watsonrx13 What I did today Nov 21 2004, 06:02 PM
watsonrx13 I used an air-hammer and a short chisel. It took m... Nov 21 2004, 06:03 PM watsonrx13 Next I needed to remove the seam-sealer and the re... Nov 21 2004, 06:04 PM watsonrx13 Finally, I cleaned the floor and covered it with O... Nov 21 2004, 06:04 PM Series9 If you use a propane torch and a putty knife, that... Nov 21 2004, 06:09 PM Jeroen nice job!
looks like there are no new nasty su... Nov 21 2004, 06:31 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 10:18 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.