 Washer nozzle install, Can't get them to pop in the holes |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914 RZ-1 |
 Mar 7 2019, 08:21 PM
Post
#1
|
|
Porsche Padawan  Group: Members Posts: 683 Joined: 17-December 14 From: Santa Clarita, CA Member No.: 18,230 Region Association: Southern California  |
I'm trying to install the nozzles for the window washer (the ones that go in front of the window where the fluid comes out). I cannot get them to pop in. I've tried soap, twisting, pushing, using a plastic trim tool to push the edges, pulling from under and combinations of these. I cannot get these to go all the way in the hole. They are the black rubber ones with chrome. Is there a trick?
|
   |
 
|
  |
Replies
| IronHillRestorations |
Mar 8 2019, 08:12 AM
Post
#2
|
|
I. I. R. C. Group: Members Posts: 6,724 Joined: 18-March 03 From: West TN Member No.: 439 Region Association: None 
|
If you're worried about dimpling the cowl, you can use the appropriate size deep well socket for supporting it from underneath
|
|
|
|
Posts in this topic
914 RZ-1 Washer nozzle install Mar 7 2019, 08:21 PM
johnlush You're on the right track. Maybe take out the ... Mar 7 2019, 08:34 PM mark04usa As I recall, the nozzles go in aimed a bit outboar... Mar 7 2019, 10:34 PM raynekat Pulling is the key.
I used a set of needle nose pl... Mar 7 2019, 11:17 PM rgalla9146 Pull from below, if the car hasn't been painte... Mar 8 2019, 06:12 AM 1adam12 Glad this was posted up as I just finished setting... Mar 8 2019, 03:12 PM
914 RZ-1 I got them in. I used a very sharp xacto knife to ... Mar 8 2019, 08:15 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 08:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.