New 914 rear wheel bearing, No to very little grease from manufacture Options

[Luke M]

So, I just purchased a set of New FAG wheel bearing (made in Germany) so I can install a set of the later (74-89) 911 rear hubs on my 914 control arms.
I saw a few you tube videos about how the bearings for the Boxster where being shipped with little to no grease in them. I figured before I install them to check the grease. Well sure enough one side had little grease and the other side had very little to no grease on the bearings. I should've taken a few pics but didn't have my phone handy. I still have another new bearing to inspect so I'll take pics of that one. I'm sure it will be the same way. Now to go pick up some grease and repack them.


So if anyone of you out there plan on replacing your rear bearing I would inspect them.

Here's a handy video which shows how to do this.

https://www.youtube.com/watch?v=l9P1R2clGAU

[Superhawk996]

(IMG:style_emoticons/default/stirthepot.gif)

Bearings don't need much "lube" to run for long periods of time especially if the loads are light and they are light in road going vehicles. Race cars pulling high lateral G's for long periods of time are another story.

What kills bearings the fastest are things like vibratory loads and false brinelling. False brinellling can easily occur on race cars that are tied down too tightly in trailers and then proceed to vibrate or oscillate the bearings with no rotary motion.

https://www.ntnglobal.com/en/products/care/...e/fretting.html

Any reputable OEM has pretty good quality control checks in place to ensure grease is put into the bearing. More applicable to new bearings. NOS predates my involvement with the bearing suppliers. Grease flow meters are built into the line. Bearing won't move to next station and/or line stops if flow meters don't register grease injection. Vision systems look for presence of bearings, cages, and grease otherwise no-go. There may even be a visual check by a real human prior to seal installation.

(IMG:style_emoticons/default/stromberg.gif) still can happen though but it is rare.

Bad information on interwebz (including me - (IMG:style_emoticons/default/lol-2.gif) ) is statistically more likely than a mainstream OEM kicking out thousands upon thousands of bad bearings.

Food for thought.