Could use a hand..., First time motor pull.... Options

[Tjmrfe]

Hey Guys, couldn’t take the leaking oil anymore....so, in a bold move, I decided to pull the motor! I’ve got everything sorted, all my ground straps and wiring is off...went down the check list, got my Tangerine plate and my dolly...now all I need is a guide, or two?...I’m more than willing to throw a BBQ together and refreshments I’m thinking the second weekend in July? 13/14....either day works...should not take too long, just four bolts right? Lol...I’m in Cornwall NY near West Point...PM me if you’ve got a free few hours that weekend, this way I can get it out and see how bad the oil leaks are!...

[ndfrigi]

you’re almost there to drop your engine. For sure you can do it by yourself.
Is your current lifter can drop your engine all the way down a furniture dolly and the highest to raise your car (rear valance) can get around 29”? so you can pull the engine. (engine and dolly height is around 28”)

Or use 2 floor jack to raise and lower your rear car during the engine removal.

1. All cables remove like clutch , accelerator, speedo
2. All wirings to top engine (F.I. or carb)
3. Tranny ground strap
4. Remove exhaust (it is fine also not removing it but easier and more space to work underneath)
5. Raise your rear a little bit enough for your to work underneath.
6. Loosen the tranny and engine mount bolts just enough for you to totally remove them later
7. Put your furniture dolly under the rear (vertical way of ur dolly)
8. Drop your rear slowly one side at a time (if using 2 floor jack) until
the engine touches your dolly (engine mount drop to one side of the padding of your dolly and rear end of dolly pad along tranny and you may need a small wood block for dolly to tranny) Note: check also your rotor that may hit the floor
9. Drop rear that engine is totally seated to your dolly. Note again: Check again if rotor is not hitting the floor.
10. Remove engine and tranny bolts.
11. Raise your rear car slowly and always check on top your engine bay to see if clearance are all okay. You may use 2 jack stand just for additional security but don’t forget to lower the floor jack every time you lower your rear until no enough space for the jack stand and you can just put them aside
12. Pull engine out