Front Suspension recomendations Options

[rcampbell2909]

Hello all,

I have done some searching and have not come up with much for recent results to guide me in a direction to make a decision in improving my front suspension. This question is in regard to a '75. I need to replace my front struts as one is leaking oil and the other seems to have no resistance left at this point. I have been running with the front around 3" lower than stock height (adjusted using the small bolt on the torsion bars). I wanted to consider any upgrades/changes while I will be changing the struts.

Should I be looking at other options to lower the front? I was shopping for struts and noticed that there is a "sport" strut in the Bilstein line to be used with lowered springs-but I have not found the springs to match...

What are my best options at this point? Just replace the struts and continue to run with the adjusters where they are for ride height? Explore lowering springs? Other options? Is there anything else I should be doing while I am in there replacing struts?

Also, what is the current thought on the various struts that are available. I see a variety I see Bilsteins, Sachs, Boge, etc... This is a street car with a large stroker 4 cylinder, but will not see much if any track time.

Thank you for any assistance that can be offered.

[jmitro]

what is your goal? just a lowered stance while retaining a decent ride quality?

first of all the 914 in stock form doesn't use any front springs - just torsion bars. you can lower the front by reindexing the torsion bars as mentioned above. If you want to retain a decent ride quality stay with the stock torsion bars and get some good bilstein strut inserts.

Lowering the front end excessively will change the camber settings to positive under high cornering loads unless you raise the spindles, which is what I did on my car. Raising the spindles will also maintain the stock strut body length so the struts don't bottom out

http://www.914world.com/bbs2/index.php?s=&...t&p=2570827

[rcampbell2909]

I must have spent too much time in the HAM shack yesterday for field day, when I wrote that post...I was thinking of the rear with the springs, as the previous owner installed KYB's and I have wondered if changing them would improve ride quality at all.

Anyway, back on topic. Yes, I am just looking for a lower stance with a decent ride quality. So if that is the case, am I understanding that I can achieve that with the Bilstein inserts for lowered suspension and reindexing the torsion bars?