 floor pan condition, tar removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Elliot_Cannon |
 May 20 2003, 09:43 PM
Post
#1
|
|
Senior Member  Group: Retired Members Posts: 1,922 Joined: 26-March 03 From: Orange County Ca Member No.: 480 Region Association: None  |
I've been reading alot about removing the tar on the floor pans lately. My floors look great inside and out. Can't see any rust under the car. I would like to get by without scraping the tar off. Is there any way you can determine if there is rust under the tar without scraping it all up? It looks like a very labor intensive job. I try to avoid hard work whenever I can but I am finding that to be impossible when working on a 30 year old car.
Cheers, Elliot |
   |
 
|
  |
Replies
| Jenny |
May 21 2003, 09:35 AM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,060 Joined: 6-January 03 Member No.: 96 Region Association: None |
I've started going at the rust areas with a wire bristle wheel attached to an electric drill. After that's done, yes, I believe I will be introduced to the art of POR-15-ing.
I heard Andy talking about sticking sound deadening material to the underside of the carpet. That way you can lift it up and check for water anytime you want. Sounds good to me! Jen |
|
|
|
Posts in this topic
Elliot Cannon floor pan condition May 20 2003, 09:43 PM
GWN7 Do you have a crystal ball? If so, tell Muller the... May 21 2003, 12:38 AM Jenny Seriously, it's a 2-3hr job to remove the tar ... May 21 2003, 12:53 AM GWN7 See...the voice of one of the 99% :) May 21 2003, 01:06 AM jridder So what is the recommended treatment after taking ... May 21 2003, 03:58 AM SirAndy after the cleanup, make sure you put "Metal-Ready"... May 21 2003, 11:50 AM Jenny What's that??
Jen May 21 2003, 11:58 AM Elliot Cannon Ah rats!!! I guess I knew what the a... May 21 2003, 11:59 AM SirAndy vortrex use a $5 plumbers torch, works great. May 21 2003, 01:18 PM Gint QUOTE
Elliot Cannon So far so good! I used my butane torch and sc... May 21 2003, 07:40 PM Brad Roberts 12$ heat gun from Harbor freight... when you ... May 22 2003, 12:54 AM
Blynes Tar removal- this works if you can find one
calle... May 22 2003, 04:23 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:27 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.