 CV joint / axle movement in and out...how much?, Got a Clunk-clunk-Clunk going on back there... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| MikeInMunich |
 Aug 29 2019, 09:48 AM
Post
#1
|
|
Member  Group: Members Posts: 392 Joined: 19-November 13 From: Munich, Germany Member No.: 16,674 Region Association: None  |
...when going slow AND turning left. Otherwise not at all. Clunks, 3 or 4, from the driver’s side, rear. Sounds as if something like the heat exchanger was resting on the trailer arm and then bounced when going over a bump. I KNOW this is not the sound and that it’s not possible. Just describing!
So, is there something up with my rear wheel bearing?i just changed out the CV joint bearings! Could it be one is already faulty?! Interested in your opinions. Danke! M.i.M. |
   |
 
|
  |
Replies
| MikeInMunich |
Sep 6 2019, 01:42 AM
Post
#2
|
|
Member Group: Members Posts: 392 Joined: 19-November 13 From: Munich, Germany Member No.: 16,674 Region Association: None |
So, I just got under there. Bolts are not mega loose, but I’m not sure if they’re loose at all because I don’t have the correct tool at hand.
Question! How much play should there be in and out for the axle? They both move in and out quite a bit! |
|
|
|
Posts in this topic
MikeInMunich CV joint / axle movement in and out...how much? Aug 29 2019, 09:48 AM
gereed75 CV can clunk and kinda bang if they are going bad ... Aug 29 2019, 09:35 PM falcor75 + 1 on cv joint bolts or that the circlip holding ... Aug 29 2019, 11:57 PM BeatNavy CV sounds likely, but also inspect the trailing ar... Aug 30 2019, 05:20 AM EdwardBlume I lost my CV on the pass side doing 60+ on the fre... Aug 30 2019, 06:59 AM ClayPerrine I lost a CV joint leaving a traffic light years ag... Aug 30 2019, 07:11 AM dlee6204 My vote is on a missing C Clip. Can you replicate... Sep 6 2019, 03:33 AM
MikeInMunich
My vote is on a missing C Clip. Can you replicat... Sep 6 2019, 03:41 AM jim_hoyland Good Question, "Also, how much play in the ax... Sep 6 2019, 05:14 AM 914Sixer Stub axle keeps the bearing in check, they should ... Sep 6 2019, 10:04 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 02:36 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.