 Engine wiring harness query |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914Greg |
 Dec 1 2019, 05:06 PM
Post
#1
|
|
Newbie  Group: Members Posts: 14 Joined: 17-November 19 From: Australia Member No.: 23,647 Region Association: None  |
I have bought a roller without an engine wiring harness, it was a 4 that will be converted to a 6 with MSD and built in alt regulator, would it be just as easy to start from scratch with a harness than mod an old one?
|
   |
 
|
  |
Replies
| 914Greg |
Dec 2 2019, 04:01 PM
Post
#2
|
|
Newbie Group: Members Posts: 14 Joined: 17-November 19 From: Australia Member No.: 23,647 Region Association: None |
Thanks for all the assistance and advice guys, when I get the car shipped I will work out the best way to go.
I'm good with wiring and have just finished reworking a harness on a 2.7 in a 911 from FI to carbs, and msd. I thought i might just start by getting a couple of multi pin connectors but i dont see them listed in the Porsche parts catalogue, are they available anywhere. |
|
|
|
Posts in this topic
914Greg Engine wiring harness query Dec 1 2019, 05:06 PM
mb911
I have bought a roller without an engine wiring h... Dec 1 2019, 05:41 PM Rosie The harness that would go from the 12 pin connecto... Dec 1 2019, 08:30 PM Mikey914 I have the ignition harness you are referring in s... Dec 2 2019, 12:05 AM IronHillRestorations If you are looking for an engine harness for a 6 c... Dec 2 2019, 07:00 AM Mark Henry Is it for a /4 or a /6? Carbs or FI?
Do you stil... Dec 2 2019, 10:40 AM IronHillRestorations The OP says "will be converted to 6" Dec 2 2019, 12:25 PM
Mark Henry
The OP says "will be converted to 6"
S... Dec 2 2019, 02:29 PM Tom I modified an existing harness for a 3.0 several y... Dec 2 2019, 05:57 PM Mikey914 We make all the connectors, so if you have a diagr... Dec 2 2019, 06:13 PM 914Greg Thanks again for all for the help and especially t... Dec 3 2019, 04:04 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th October 2025 - 02:27 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.