Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> New CHT install question, Appears to be displaying ambient temp not engine temp
DRPHIL914
post Feb 16 2020, 06:23 PM
Post #1


Dr. Phil
*****

Group: Members
Posts: 5,830
Joined: 9-December 09
From: Bluffton, SC
Member No.: 11,106
Region Association: South East States



Has anyone had this issue installing a Dakota Digital CHT gauge?
Red and yellow wires are connected, as are ground and power wires as instructed in directions.

Any thoughts or ideas? I went thru their trouble shooting , this issue is not addressed

Phil
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
michael7810
post Feb 16 2020, 07:39 PM
Post #2


Senior Member
***

Group: Members
Posts: 1,082
Joined: 6-June 11
From: Scottsdale, AZ
Member No.: 13,164
Region Association: Southwest Region



The extension wire can be installed backwards and it won’t work properly. There is a specific end that goes on the sensor and the other side on the gauge.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
DRPHIL914
post Feb 16 2020, 09:05 PM
Post #3


Dr. Phil
*****

Group: Members
Posts: 5,830
Joined: 9-December 09
From: Bluffton, SC
Member No.: 11,106
Region Association: South East States



QUOTE(michael7810 @ Feb 16 2020, 08:39 PM) *

The extension wire can be installed backwards and it won’t work properly. There is a specific end that goes on the sensor and the other side on the gauge.


Thanks for the pointer and you hit it on the head. Even thought I have the wires connected yellow to yellow and red to red, that appears to in this case be backward and therefore it was only reading ambient temp not the head temp, switched the wires around at gauge, and I now have correct temp displaying.

Thanks Michael
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 12th July 2025 - 04:22 PM