 Refinishing hubs and stubs |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Qarl |
 May 21 2003, 05:46 PM
Post
#1
|
|
Shriveled member  Group: Benefactors Posts: 5,233 Joined: 8-February 03 From: Florida Member No.: 271 Region Association: None   |
Okay... I'm going to refinish/restore a set of early 911 hubs and stub axles. The set I have is in very good condition, the splines and studs are all great. There is some slight surface rust on the cast metal part of the stub axle. I figure I'm going soak the part in marine clean first, then tape up the splines and bead blast the whole stub axle.
Then what? How should I protect the freshly blasted metal. I know the splines of the hub will be protected with grease... How did they come new from the factory? Thanks, |
   |
 
|
  |
Replies
| Bleyseng |
May 22 2003, 05:41 PM
Post
#2
|
|
Aircooled Baby! Group: Members Posts: 13,036 Joined: 27-December 02 From: Seattle, Washington (for now) Member No.: 24 Region Association: Pacific Northwest |
cosmoline is used was used to preserve parts as its a coating. Washes off with solvent as its a temporary coating. Friend of mine had a after school job at the VW/Porsche Dealer where he washed the cosmoline off the VW and Porsches when they arrived from the shipper. Great fun that job was.
So yeah, if the parts were new and off the shelf they would have been coated in cosmoline. Geoff |
|
|
|
Posts in this topic
Qarl Refinishing hubs and stubs May 21 2003, 05:46 PM
Mueller Por-15 works nice on those parts. I'm not too ... May 21 2003, 06:17 PM Gint I did the same thing to the last car I had. I pow... May 21 2003, 07:22 PM Qarl What about cosmoline?
Could the factory parts h... May 21 2003, 08:31 PM Lawrence914-6 Yeah, Mike... but you do your own powdercoating in... May 22 2003, 11:15 AM Gint :D May 22 2003, 03:19 PM campbellcj You wouldn't believe how nasty the arms and st... May 22 2003, 03:25 PM Qarl Chris:
What did you do to your hubs to fix things... May 22 2003, 04:22 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 02:25 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.