Rear Rotor Removal, rusted stuck? Not Anymore!, Two Screws? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Rear Rotor Removal, rusted stuck? Not Anymore!, Two Screws? |
cassmcentee |
Mar 27 2020, 02:00 PM
Post
#1
|
Member Group: Members Posts: 180 Joined: 12-July 18 From: Squaw Valley, CA Member No.: 22,304 Region Association: Central California |
Is the rear rotor held on to the hub by these two screws at this point?
I have Soaked/Heated/Hammered but the screws aren't budging. Am I missing something here??? My guess is they are rusted in place... I have a torch with a rosebud tip, didn't heat the rotor to red thinking that I could possibly warp the rotor...so I just went close to red... Do I have to drill these and then tap them out? Thank You, Cass |
bdstone914 |
Mar 27 2020, 10:12 PM
Post
#2
|
bdstone914 Group: Members Posts: 4,536 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
@cassmcentee
After you get the screws out you may find the rotor stuck to the hub. There are two threaded holes that take an 8mm bolt. Screw in two bolts sequentially tightening. Most all rotors that fit over hubs have them. Attached thumbnail(s) |
Lo-Fi Version | Time is now: 7th June 2024 - 11:11 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |