 Engine bay pad, Adhesive removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Allan |
 Dec 11 2004, 01:42 PM
Post
#1
|
|
Teenerless Weenie  Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California  |
Anybody got a recommendation on how to remove all the adhesive they used to hold the engine bay pad in. Wont come off very well with a wire brush and carb cleaner just makes me high.
|
   |
 
|
  |
Replies
| xsboost90 |
Dec 12 2004, 10:46 AM
Post
#2
|
|
Senior Member Group: Members Posts: 1,393 Joined: 2-August 04 From: cincinnati Member No.: 2,432 |
180 grit sandpaper on a d/a....
Attached image(s) 
|
|
|
|
Posts in this topic
Headrage Engine bay pad Dec 11 2004, 01:42 PM
Deano I am up against the same problem. Back in Septembe... Dec 11 2004, 03:32 PM 9146986 At my shop we use the 2" & 3" green 3M bristle dis... Dec 11 2004, 03:57 PM joea9146 Acetone will cut the glue... and also remove some ... Dec 11 2004, 04:01 PM trekkor When I repaint the engine bay I'm going to use... Dec 11 2004, 04:50 PM newdeal2 Use spray on or brush on paint remover...I found i... Dec 11 2004, 05:44 PM newdeal2 After: Dec 11 2004, 05:45 PM newdeal2 After: Dec 11 2004, 05:46 PM newdeal2 With engine in [and after cleaning up some of the ... Dec 11 2004, 05:47 PM 914rrr 3M has a paint stripper wheel that mounts to a sta... Dec 11 2004, 10:04 PM vsg914 Standard (500 grade) lacquer thinner will cut the ... Dec 11 2004, 10:15 PM rhodyguy i wish i had known the 3M trick. hours with carb c... Dec 11 2004, 10:29 PM kermit ... Dec 12 2004, 02:01 AM newdeal2 The PO made it and it does work. I will be doing a... Dec 12 2004, 06:45 AM Bleyseng lacquer took it right off for me without destroyin... Dec 12 2004, 10:05 AM Howard <... Dec 12 2004, 10:35 AM boxstr Hey Guys and Gals, If you are going to spend all o... Dec 12 2004, 10:48 AM Headrage Thanks guys. I'm going to pull it outside and... Dec 13 2004, 12:06 PM Ferg Great timing on this thread, i'm starting this... Dec 13 2004, 12:28 PM
mike_the_man I had a party once and a friend of mine had a litt... Dec 13 2004, 02:27 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st July 2025 - 01:42 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.