 Tail Shift issues, Trouble shifting into fourth |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sjhenry1075 |
 Jun 19 2020, 01:05 PM
Post
#1
|
|
Member  Group: Members Posts: 268 Joined: 22-July 12 From: Stevensville, MD Member No.: 14,709 Region Association: North East States 
 |
When I'm driving my car it does not like to go into fourth gear. Every other gear is fine except fourth. The only way it does go into fourth gear is if I shift as if it's going into fourth, but it goes into 2nd instead. I pull it out, then slide it back into fourth and it goes into gear. Any ideas what this could be?
|
   |
 
|
  |
Replies
| rhodyguy |
Jun 19 2020, 02:13 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,090 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
There is also a rolled pin inside the tail shift where the rod enters the trans. Covered with an acess plate.
|
|
|
|
| brant |
Jun 19 2020, 02:18 PM
Post
#3
|
|
914 Wizard Group: Members Posts: 11,635 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
|
QUOTE(rhodyguy @ Jun 19 2020, 02:13 PM)  There is also a rolled pin inside the tail shift where the rod enters the trans. Covered with an acess plate. We replace that pin with a hardened allen bolt. solves the problem permanently for track use brant |
 |
|
Posts in this topic
sjhenry1075 Tail Shift issues Jun 19 2020, 01:05 PM
brant it could be bushings.
it could be adjustment of th... Jun 19 2020, 01:34 PM
sjhenry1075
it could be bushings.
it could be adjustment of t... Jun 19 2020, 01:43 PM brant
it could be bushings.
it could be adjustment of ... Jun 19 2020, 02:09 PM rhodyguy Do you have to tap/thread the lever shaft and shif... Jun 19 2020, 02:24 PM brant
Do you have to tap/thread the lever shaft and shi... Jun 19 2020, 02:39 PM sjhenry1075
Do you have to tap/thread the lever shaft and sh... Jun 19 2020, 11:15 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 12:49 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.