 Heater Duct Joint Seal, Is it metal-to-metal or is there a soft seal there? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Highland |
 Aug 19 2020, 03:09 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 542 Joined: 8-August 11 From: San Diego, CA Member No.: 13,418 Region Association: Southern California  |
When reassembling the heater ducts under the engine is there a high temp sealing material that goes between the joins or is it just metal on metal?
Picture is just an example of the joints, but I'm asking about all of them.  |
   |
 
|
  |
Replies
| Mikey914 |
Aug 20 2020, 10:39 AM
Post
#2
|
|
The rubber man Group: Members Posts: 12,767 Joined: 27-December 04 From: Hillsboro, OR Member No.: 3,348 Region Association: None 
|
Yes the original was more of a cork material. We made the seal from a high temp silicone so you could reuse it if you want. We also include stainless screw with allen heads so that you can remove easier without stripping as this area of the car tends to get quite dirty, and these can corrode easily (stock).
|
|
|
|
Posts in this topic
Highland Heater Duct Joint Seal Aug 19 2020, 03:09 PM
ndfrigi 914rubber has them
Aug 19 2020, 03:54 PM IronHillRestorations The 914 Rubber piece is the best way to go, but be... Aug 19 2020, 06:12 PM nathanxnathan Besides the seal under the "cap" I'v... Aug 19 2020, 06:23 PM BillC In addition to the rectangular gasket shown in the... Aug 20 2020, 02:56 PM
bdstone914
In addition to the rectangular gasket shown in th... Aug 20 2020, 03:32 PM BillC dup Aug 20 2020, 08:07 PM BillC IIRC, the gasket was silvery and didn't look l... Aug 20 2020, 08:10 PM nathanxnathan The seal here was cork - probably should have remo... Aug 21 2020, 12:42 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:50 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.