 Weber 44 IDF insulators, Gasket size |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| simonjb |
 Oct 4 2020, 03:19 PM
Post
#1
|
|
KiwiMan  Group: Members Posts: 566 Joined: 18-October 16 From: Stamford, Connecticut Member No.: 20,505 Region Association: North East States 
 |
Hi,
So I am installing a set of insulator gaskets to reduce the heat to the carbs and cut back on fuel boiling after a drive. I ordered the kit from partsklassic. Seemed good until I went to instal the gaskets that go either side of the 44 Insulator. The gaskets are smaller than the insulator - 41 - see pics below. I've sent them an email. But in the meantime I've looked for 44 size and most places have a gasket for 40/44 IDF which implies they use the same gasket for 40 or 44. Can this be correct?     |
   |
 
|
Posts in this topic
rhodyguy If the stud holes work, trim to fit. Not uncommon.... Oct 4 2020, 04:05 PM porschetub They look more like 911 intake gaskets ?,sorry to ... Oct 4 2020, 04:26 PM simonjb These fit between the Manifold and the carbs....Cu... Oct 4 2020, 05:33 PM
rhodyguy Something like this in between the carbs and the i... Oct 4 2020, 07:10 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 12:07 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.